How to Clean Dried Latex Paint from Paint Sprayer

How to Clean Dried Latex Paint from Paint Sprayer?

How to Clean Dried Latex Paint from Paint Sprayer? It is of crucial importance to clear dried latex paint from your paint sprayer. As you can already assume, if it is not properly cleaned, the spray machine will not function as it is planned.

The paint usually builds up within the sprayer very easily, sadly, and then dries in there. This can trigger stalking of the bearing. In contrast, the dye can also dry up at the tip of the template. As you know, the tip of each sprayer has a small hole through which the dye is pushed. If it gets blocked, it will not be possible for the colorant to go through it at all.

Things You Need

  • Two 5-gallon buckets
  • Pliers
  • Garden hose
  • Small soft-bristle brush

Step By Step Guide on How to Clean Dried Latex Paint from Paint Sprayer

Start by removing the tip from the end of your weapon and the spray guard. The tip typically slides inside hold on the side of the spray guard. Take the tip out of the guard carefully.

Take some warm water and wash as thoroughly as possible the spray gun. There’s a soft bristle brush that can be of great help here. Try to look through the hole while holding it toward the light source once you have washed the tip. You ought to be able to see the light through it.

Carefully remove the top part of the weapon from the handle. Inside the handle, there is a filter to extract it from your weapon and then clean it with water as thoroughly as you can, i.e. until there is no more color on it. Put the gun back together, but without the filter (this is only temporary). Take a couple of channel locks or pliers to catch the handle and rotate the top by hand in case you can’t get it apart.

Take your packed 5-gallon bucket and fill it with clean water. Place the collection of the siphon tube (located on the front of the sprayer) in the container. Switch the sprayer on in its prime position for a few moments after that.

Switch the system to the “on” position once pumping (or drawing water) has been enabled. After that, aim the weapon of the prototype into your second bucket and spray it until the hose and the sprayer itself have no more paint.

Take a bucket and use clean water to refill it. Turn your device back to its prime position and allow it to reign until the tube attached to the siphon is completely clear, i.e. without any dye on it. Switch the device back to its “on” role and spray water through its weapon and hose until you see clean water spraying.

There is an inlet strainer at the end of the siphon hose-it looks like a window, and by turning it counterclockwise, you can delete it. Wash it with some water and put it back in place carefully. Remove from the handle the top of the gun and finally put the filter back in its place.

Do not forget to use fluid after each use of the throat seal. His job is to protect the rod of the pump and the packaging from being encrusted with dried paint as well as unnecessary wear.

The water is forced into a hole in the front of the sprayer. The user manual that came with your design would specify the exact amount of seal fluid in the throat that you will need to use. After each use, most models need three to five falls.

The cleaning process is quite similar to the one mentioned above if you are using oil-based colorant. But, instead of liquid, you will need to use paint thinner or mineral spirits.

Typically, you don’t need to use a full bucket-you’ll only need the amount that will allow you to prime the thinner device. This should prevent the dye from drying in the process.

Even though it may seem difficult, it can be done very easily to clean dried latex paint from your equipment once you get the hang of it. And it is of crucial importance to properly clean your sprayer after each use-it is something that gives your tool a longer lifespan and enhances the appearance of your finished projects.

Related Buyer’s guides:

Leave a Reply